Vanguard BIG BLOCK M540000, Repair Manual, Page: 58 / 168

4. Remove the voltage regulator ( D , Figure 51 and Figure
52) from the engine and set aside.
52
Starter Motor
1. Remove starter motor positive terminal nut ( A , Figure
53) and remove the wires from the terminal.
53
2. Remove the ignition start switch wire ( B ) from the starter
solenoid terminal.
NOTE: Some engines may be equipped with a starter motor
support bracket. Removal of this bracket is required for starter
motor removal. If equipped, proceed to steps 3 and 4. If your
engine is NOT equipped with a starter motor support bracket,
skip to step 5.
3. If equipped, remove the starter motor support bracket to
starter motor bolt ( A , Figure 54).
54
4. Remove the 2 starter motor support bracket to engine
block nuts ( B ).
5. Remove the 2 starter motor mounting fasteners ( A ,
Figure 55).
55
6. Remove the starter motor ( B ) from the engine and set
aside.
59