2. Rotate hex (
B
) to install adapter (
C
) and diverter (
D
) to
crankcase flange.
NOTE:
Orient diverter so that the locator tab faces toward
the PTO side crankcase cover side as shown.
3. Tighten adapter to
240 lb-in
(27.1 Nm).
4. If equipped, install the optional drip tray onto the
crankcase bosses beneath the oil filter.
5. Start by hand the 2 drip tray fasteners (
A
Tighten to
70 lb-in
(7.9 Nm).
227
Oil Cooler
1. Install the oil cooler inlet and outlet hoses onto the
diverter valve oil fittings. Squeeze the tangs of the hose
clamps (
D
, Figure 228) and slide clamps along the hose
until positioned over the diverter valve oil fittings.
228
2. Install 2 fasteners (
C
) to secure the oil cooler bottom
bracket to the engine back plate.
3. Install the fastener (
A
) to secure the oil cooler top bracket
(
B
) to the blower housing.
Oil Filter
1. Verify the oil filter mount flange (
A
, Figure 229) is clean
and dry.
229
2. Lubricate gasket of
new
oil filter with a thin film of clean
engine oil (
B
).
3. Install oil filter (
C
), and hand tighten until gasket contacts
filter mount flange. Using a 76mm-14 Flute end cap
style oil filter wrench (
D
) with ratchet and extension
bar, tighten oil filter to
75 lb-in
(8.5 Nm). Do not use air
tools.
161
Summary of Contents for BIG BLOCK M540000
