Vanguard BIG BLOCK M540000, Repair Manual, Page: 154 / 168

4. If equipped with a manual rotary throttle lever, install
the throttle lever ( B , Figure 216) with fastener ( A ) and
washer stack ( C ) to the throttle shaft ( D ). Tighten to 90
lb-in (10.2 Nm).
216
5. Install the key switch cover ( C , Figure 217) onto the
engine atop the blower housing.
6. Connect the choke rod to the speed control bracket by
inserting the end of the rod into the bushing hole ( A ,
Figure 215). Attach the retaining clip to the choke rod.
7. Connect the throttle control shaft ( D , Figure 216) to
the speed control bracket by pushing the shaft into the
bracket groove until captured.
8. Start by hand the 2 cover fasteners and retaining
washers ( A-B , Figure 217). Tighten to 30 lb-in (3.4 Nm).
217
Intake Elbow Cover
1. If equipped, connect MIL/tachometer/hourmeter harness
connector to component connector on the back of the
cover.
2. Install air intake elbow cover ( E , Figure 217) atop
the engine. Align the mounting holes to the threaded
mounting holes of the support brackets.
3. Start by hand the 2 cover fasteners that connect the
cover to the air cleaner bracket ( F ). Tighten to 90 lb-in
(10.2 Nm).
4. Start by hand the 2 cover fasteners that connect the
cover to the fuel pump module bracket ( D ). Tighten to 90
lb-in (10.2 Nm).
155