Disassembly - Carburetor - Vanguard Model 610000
The Vanguard Model 610000 OHV V-Twin utilizes a fixed jet,
two-barrel, side draft, flo-jet carburetor. Except for idle speed,
the carburetor is non adjustable. The carburetor incorporates
a fuel shut-off (anti-afterfire) solenoid that controls the flow to
the fuel metering system. The solenoid is controlled by the
ignition switch.
1. Remove the 4 float bowl fasteners (
A
, Figure 146) and
remove the float bowl (
B
) and gasket. Discard gasket.
2. Using a thin profile wrench, remove the anti-afterfire
solenoid (
C
) from the float bowl. Discard sealing washer.
3. Remove the main jets (
D
) from the float bowl.
4. Remove the float hinge pin, float (
E
), and needle from the
carburetor body.
5. Remove the limiter caps and mixture adjustment screw
(
F
) from both sides of the carburetor.
6. Remove the choke plate fasteners and choke plate (
G
).
7. Remove the circlip and washer that secure the choke
shaft to the carburetor. Remove the choke shaft (
H
) and
bushings from the carburetor.
8. Mark the throttle plates (
I
) before removal so they can be
re-installed in the original position.
9. Remove the throttle plate fasteners and throttle plates.
10. Remove the circlip and washer that secure the throttle
shaft (
J
) to the carburetor. Remove the throttle shaft,
bushings, and seal from the carburetor. Discard seal.
115
Summary of Contents for BIG BLOCK M540000
