SECTION 6: MAINTENANCE
AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 88
090019-OP_r0
3. Run a new serpentine belt into place about
the generator, engine and idler pulleys as
shown in
Figure 6-18
. Keep in mind when
routing the belt that:
• Belt treads face the inside of the main
pulleys, as shown in item [
E
].
• Begin the belt routing by first wedging the
belt between the compressor belt
dampener [
F
] and the DC pulley, as
shown in the inset view of
Figure 6-18
.
Once the belt is beyond the dampener, it
can be placed over the DC pulley, and
then continued from there.
4. When the belt has been situated onto each
track groove on the drive pulleys and the
idler, the tension will need to be reset via the
position of the idler sheave [
B
], and checked.
To reset and check the generator belt
tension, refer to
Section 6.5.7.9, Re-
tensioning the Generator Serpentine Belt
.
5. After the generator serpentine belt has been
set and checked, the compressor drive belts
need to be repositioned. Consult
Section
KEY
DESCRIPTION
KEY
DESCRIPTION
A
AC GENERATOR PULLEY
D
ENGINE PULLEY (generator belt to inside pulley
track)
B
DC (WELDER) GENERATOR PULLEY
E
BELT TREAD - Faces inward (inside) of belt track
C
IDLER SHEAVE
F
COMPRESSOR BELT DAMPENER
Figure 6-18: Generator Drive V-Belt - Routing Onto Track
C
A
D
E
B
E
F
F
