SECTION 6: MAINTENANCE
AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 98
090019-OP_r0
cap. To disengage the holder, grasp and lift upwards.
Once it is free, remove the cap to access the fuses.
The 25 amp generator breakers are located behind the
face plate at the lower portion of the canopy. To access
these breakers, the face plate must be removed. Refer to
Figure 6-26
for aid in replacing the DC generator
breakers.
The two 20 amp receptacle breakers are located inside
the instrument panel box (
Figure 6-26
[
B
]).
6.7 STORAGE AND INTERMITTENT
USE
6.7.1 INTERMITTENT USE
If the unit is not used very regularly always treat the fuel
with a fuel stabilizer.
Check all belts and hoses for signs of deterioration such
as visible surface cracks, stiffness or discoloration.
6.7.2 LONG TERM STORAGE
Disconnect the battery cable that is connected to the
positive (+) side of the battery.
Depressurize the air tank and open the drain valve on the
tank.
Cover the unit with a tarp or plastic to prevent the
accumulation of dust, but leave the bottom open for air
circulation.
Fill gas tank with fuel and fuel stabilizer to prevent
moisture build-up in the tank.
System Component or
Part Group Task
Manual
Section
Location
Storage and Intermittent Use
6.7
page 98
Intermittent Use
6.7.1
page 98
Long-term Storage
6.7.2
page 98
CAUTION
Parts can wear or degrade over time. Do
not operate with worn or degraded
equipment parts. Replace as needed.
