SECTION 6: MAINTENANCE
AIR N ARC
®
200 SERIES ALL-IN-ONE POWER SYSTEM
®
PAGE - 92
090019-OP_r0
SCHEDULE TABLE
. Check the engine oil level when the
engine is off, and the oil allowed to settle.
1. Locate the engine dipstick handle [
A
] and
remove.
2. Wipe off the excess oil on the dipstick blade,
and replace the dipstick back into the engine
tube in order to get a clear level reading.
3. Remove the stick again, and observe where
the oil level shows at the gauge-end of the
stick [
G
]. Acceptable level should be within
TOOLS NEEDED
REPLACEMENT
PART(S)
Clean Cloth
Engine Oil
I
(if
necessary)
Funnel (to add oil if
necessary)
I
Engine may need additional amount of oil if low. Consult
Engine Operator’s Manual for oil grade used, amount
needed, and oil change intervals. Consult
Section 6.5.9.3,
Replacing the Engine Oil
,
to change the engine system oil.
KEY
DESCRIPTION
KEY
DESCRIPTION
A
ENGINE OIL DIPSTICK HANDLE
E
RUBBER GASKET
B
ENGINE OIL FILL PORT
F
ENGINE OIL DRAIN PLUG
C
ENGINE OIL FILTER
I
G
Acceptable range for engine oil level between:
G
1
(FULL), and
G
2
(LOW) - DO NOT OVERFILL
D
THREADED CENTER HOLE
I
Order Replacement Engine Oil Filter No. EN38480
Figure 6-21: Engine Oil Maintenance
F
D
E
B
C
G
1
G
2
A
