13
FAS-402-CH/FAS-602-CH Series Operating Instructions Ver. 1.05E
This sealer is an impulse sealer with sponges located on
the sealing section to secure the nozzle prior to air
removal. The air supplied by air pump drives the valve,
cylinder, and nozzle to complete the sealing.
In addition, the vacuum and air removal is done going
though nozzle suction port.
The selector switch on the panel allows the operator to
choose from three modes of operations: "sealing only"
and "manual vacuum and sealing" and "timer-based
vacuum and sealing".
The operation process is controlled by control panel
and performed just simply by pressing the foot switch.
1
The impulse sealer is a machine which sends strong electric current quickly to the thin ribbon heater,
which presses against the film and instantly heat seals the package. Though this machine yields
superior quality sealing, it is not compatible with films thicker than that indicated in the diagram
below, sponge-like sheets, and materials which are not able to withstand high heat.
2
Film thickness limits for the FAS-402-CH/FAS-602-CH series are described below. The machine
cannot seal bags which are thicker than that indicated.
The machine may malfunction if you try to exceed the limits of the machine.
Heating method
Heater width
)LOPWKLFNQHVVWRWDOWKLFNQHVVRISLOHG¿OP
Single-side heating
5mm
Less than 0.3mm
Single-side heating
10mm
Less than 0.4mm
Double-side heating
10mm
Less than 0.5mm
1 Place a pouch
2 Vacuum
3 Sealing
4 Finish
4 Outline of structure
5 Proper operating boundaries for the FAS-402/ 602-CH series
Bag
Sponges
Sealing section
Nozzle forward
Table
Vacuum
Press
Nozzle backward
Nozzle forward
Pressure lever raise up
