61
FAS-402-CH/FAS-602-CH Series Operating Instructions Ver. 1.05E
If you are experiencing problems with the machine, please refer to the chart below.
Carefully follow the directions in the operating instructions when replacing parts.
Please consult
Van der Stahl Scientific
if after referring to the chart, the problem cannot be resolved.
Please refer any questions regarding replacement of parts not listed in the operating instructions or
adjustment of such parts to
Van der Stahl Scientific
.
Items marked with
" ※ "
mark in the "Solutions" column refer to the fact that these problems should be
addressed by an electrician. If there are any problems, please contact
Van der Stahl Scientific
.
Problems
Check
Solution
Sealing is not clean.
+HDWLQJHOHPHQWÀXRURJODVVVKHHW
DQGRUVLOLFRQHUXEEHUZKLWHDUH
dusty.
Wipe with the clean cloth.
Fluoro glass sheet is damaged.
Cut the damaged part and slide to use
WKHQHZSDUWRIWKHÀXRURJODVVVKHHW
Silicone rubber is damaged.
5HSODFHWKHVLOLFRQHUXEEHUZKLWH
Glass tape is damaged.
Replace the glass tape.
Set heating temperature is too high.
Set the heating temperature at
PLQLPXPWRPDNHDVXI¿FLHQWVHDO
Set cooling temperature is too high.
Adjust the cooling temperature lower.
Heating element is easily damaged.
Set heating temperature is too high.
Set the heating temperature at
PLQLPXPWRPDNHDVXI¿FLHQWVHDO
Set cooling temperature is too high.
Adjust the cooling temperature lower.
Glass tape or Sarcon sheet is
damaged.
Replace the glass tape or Sarcon
sheet.
Electrode is damaged.
Replace the electrode.
Sealing is uneven on the right and left
sides.
Silicone rubber is damaged.
5HSODFHWKHVLOLFRQHUXEEHUZKLWH
Heating element is bent in the center.
Electrode is damaged.
※
Replace the electrodes.
6LOLFRQHUXEEHUZKLWHKDVEHFRPH
uneven.
5HSODFHWKHVLOLFRQHUXEEHUZKLWH
Heat lamp does not turn ON even
though the power switch is ON.
----------
Heat lamp might be damaged.
※
Replace the control unit.
Items marked with an asterisk * in the "Solutions" column refer to the fact that these problems
should be addressed by electrician. If there are any problems, please contact
Van der Stahl
Scientific
.
15 Common problems and solution
Warning
When replacing parts, be sure to unplug power cord from the wall outlet.
