Valley VRI-iS, Installation Manual

Page: 17 / 102

17
Installation Instructions
Wiring
16. Wire the collector ring based on whether there is
a running light or not.
• Without Running Light - see Figure 17-1.
(a) Refer to the VRI-iS Slip Ring Wiring Field
Install.
(i) Wire the slip ring to the resolver cable
(from control panel) and four position
terminal strip.
(ii) Wire 50 foot VRI-iS cable to the four po-
sition terminal strip.
(b) Use wire ties to secure the slip ring wires
and VRI-iS cable to wire tie holders on sen-
sor bracket.
• With Running Light - see Figure 17-2.
(a) Wire the running light to collector ring. Refer
to the Running Light Field Wiring.
(b) Refer to the VRI-iS Slip Ring Wiring Field
Install.
(i) Wire the slip ring to the resolver cable
(from control panel) and four position
terminal strip.
(ii) Wire 50 foot VRI-iS cable to the four po-
sition terminal strip.
(c) Use wire ties to secure the slip ring cable
and VRI-iS cable to wire tie holders on sen-
sor bracket.
17. Install the cover on the collector ring.
18. If you know the GPS coordinates for the pivot
point, continue with Use Edit to Setup Control
Panel for GPS Position in the Troubleshoot-
ing section on page 74 (ICON5/X) or 76
(ICON10/1). If not, continue with Temporarily
Install GPS Position Tower box on the next page.
4
6
2
5
4
3
5
1
Figure 17-1 Aeromotive Collector Ring Shown
1. Slip Ring Wires
2. VRI-iS Cable
3. Terminal Strip 4. Wire Tie
5. Wire Tie Holder
6. Sensor Bracket
5
6
4
5
6
7
3
1
2
Figure 17-2 Aeromotive Collector Ring Shown
1. Running Light Cable
2. Slip Ring Wires
3. VRI-iS Cable
4. Terminal Strip 5. Wire Tie
6. Wire Tie Holder
7. Sensor Bracket