![background image](http://html1.mh-extra.com/html/valley/vri-is/vri-is_installation-manual_3239219014.webp)
14
Installation Instructions
Install Slip Ring (Continued)
10. Identify the correct sensor bracket to use based
on the type of collector ring. See Figure 14-1.
• Aeromotive
collector ring - use the SHORT
sensor bracket pn 03E0015.
• Insul-8
collector ring - use the LONG sensor
bracket pn 03E2588.
11. Attach a four position terminal block to the sen-
sor bracket with two #4 x 5/8 in - 40 screws and
hex nuts.
12. Push a wire tie holder into each .188 in (4.78
mm) hole on the sensor bracket.
13. Attach sensor bracket to collector ring base with
one 5/16 x 1-3/4 cap screw, lock washer and hex
nut.
• Aeromotive
collector ring - install sensor
bracket on the existing 5/16 in cap screw op-
posite to the 1/2 in NPT pipe plug to gain maxi-
mum clearance for the sensor arm.
• Insul-8
collector ring - remove knockout in the
bottom of the collector ring housing.
2
5
8
1
4
7
3
6
9
5
Figure 14-1 Aeromotive Collector Ring
1. Four Position Terminal Block
2. Sensor Bracket
3. #4 x 5/8 -40 Screw
4. #4 Hex Nut
5. Wire Tie Holder
6. Collector Ring Housing
7. 5/16 x 1-3/4 Cap Screw
8. 5/16 Lock Washer
9. 5/16 Hex Nut
Summary of Contents for VRI-iS
