VALCO MELTON VCX, Service Manual

Page: 63 / 213

MC083 - VCX Service Manual Section 4 - Setup
63
Section 4 - Setup
Adding Modules
The Power Supply Module is always on the left side of the VCX Control. Additional modules are added from left to
right. Always place the Tracking Control Module(s) in the slot(s) on the right.
Module choices include Pattern Control Modules (PCM), Inspection Control Modules (ICM), Tracking Control Modules
with Ejector (TCM-E), and Color Code Reader (CDS).
Removing the Cover of the VCX Control
WARNING! Turn off all power and disconnect the power cord to the VCX Control before adding or
removing modules. FAILURE TO OBSERVE WARNING MAY RESULT IN DEATH,
PERSONAL INJURY, AND/OR EQUIPMENT DAMAGE.
To remove the cover of the VCX Control, use a hex wrench to turn the hex latches 1/2 turn to unhook the 4 latches
that lock the cover onto the base (see Figure 4-1). Carefully remove the cover by grasping the cover “cup” handle and
lifting the cover off of the unit. Reverse this procedure to replace the cover.
Figure 4-1. Remove the VCX Control Cover