Vacon 50X, User Manual

Page: 56 / 132

55 vacon
using macro mode and getting a quick start
Tel. +358 (0)201 2121 • Fax +358 (0)201 212205
6
850 PI Configure No PI 86
851 PI Feedback Vin1 87
852 PI Prop Gain 0 87
853 PI Int Gain 0 87
854 PI Feed Gain 1000 87
857 PI High Corr 100.00 87
858 PI Low Corr 0.00% 87
Para. # Parameter Name Default See Page
203 Stop Key Remote Coast 63
204 Ref Select Vin1 63
205 Vin1 Config 0-10 V 64
206 Vin1 Offset 0.00% 64
207 Vin1 Span 100.00% 64
401 Ramp Select ART-DI 67
501 V/Hz Select Pump Fxd 71
608 Restart Number 0 78
609 Restart Delay 60 sec 78
702 Imet Config Current Out 80
703 Imet Span 100.0% 80
704 Imet Offset 0.0% 80
721 DI1 Configure Preset 1 81
722 DI2 Configure Preset 2 81
723 DI3 Configure Preset 3 81
724 DI4 Configure Ref Switch 81
725 DI5 Configure Fault Reset 81
803 PWM Frequency 16.0 kHz 83
804 Display Mode Output Freq 84
Table 20:Pump Application Macro
(Core Factory Application from Table 17, plus the following parameters)
Para. # Parameter Name Default See Page
203 Stop Key Remote Coast 63
204 Ref Select Vin1 63
205 Vin1 Config 0-10 V 64
206 Vin1 Offset 0.00% 64
207 Vin1 Span 100.00% 64
208 Cin Config 0-20 mA 50 64
209 Cin Offset 0.0% 65
210 Cin Span 100.0% 65
211 Vin2 Config 0-10 V 65
212 Vin2 Offset 0.00% 65
213 Vin2 Span 100.00% 65
Table 21:Pump with PI Application Macro
(Core Factory Application from Table 17, plus the following parameters)
Para. # Parameter Name Default See Page
Table 19:Fan with PI Application Macro
(Core Factory Application from Table 17, plus the following parameters)