V2 NIUBA-24V, Manual

Page: 61 / 132

ENGLISH
- 59 -
PARAMETER VALUE DESCRIPTION DEFAULT MEMO
CoS
Safety ribbon input
This menu allows enabling the input for safety ribbon
no
no
Input disabled (ignored by the control unit)
Ch
Input enabled during closure and disabled during opening.
The intervention of the safety ribbon cause the reopening of the barrier
and the disactivation of any automatic closing
Co.tE
Test of the safety ribbons
This menu allows setting the method of control of the safety ribbons
working.
no
no
Test disabled
rESi
Test enabled for conductive rubber safety ribbons
Foto
Test enabled for optical safety ribbons
S.EnC
Encoder sensitivity
0
0 - 7
This menu allows the sensitivity of the rate sensor to be adjusted.
A decreased rate below the set threshold indicates the presence of an
obstacle.
If set to
0
the obstacle is only detected when the barrier is stopped.
When the sensor intervenes, the barrier stops and is operated in the
reverse direction for 3 seconds to remove the obstacle.
The next start command restarts the movement in the previous direction
i.Adi
Enabling the ADI device
This menu makes it possible to enable operation of the device connected
to the ADI connector.
PLEASE NOTE: selecting
Si
and pressing OK accesses the configuration
menu for the device connected to the ADI connector.
This menu is managed by the device itself and is different for each device.
Please refer to the manual for the device.
If the
Si
option is selected, but no device is connected, the display will
show a series of dotted lines.
Exiting the ADI device configuration menu returns to the
i.Adi
option
no
no
Interface disabled, any signals will be ignored
Si
Interface enabled
FinE
End of Programming
This menu allows to finish the programming (both default and
personalized) saving the modified data into memory
no
no
Do not quit the programming
Si
End of programming