V2 NIUBA-24V, Manual

Page: 57 / 132

ENGLISH
- 55 -
PARAMETER VALUE DESCRIPTION DEFAULT MEMO
t.rSE
Holding magnet delay time
0.0”
0.0” - 5.0”
This menu allows regulating the delay with which the holding magnet
jams after the barrier has finished closing.
m
ATTENTION: if the holding magnet is not present to set up this
parameter to zero.
PLEASE NOTE
: The locking electromagnet is connected to the accessory
power supply. Hence, it is essential to deactivate the energy saving
function to use it
P.SEr
Holding magnet power
0
0 - 1 00
This menu allows regulating the power with which the electromagnetic
vacuum gripper becomes blocked.
m
ATTENTION: if the holding magnet is not present, set up this
parameter to zero.
PLEASE NOTE:
The locking electromagnet is connected to the accessory
power supply. Hence, it is essential to deactivate the energy saving
function to use it.
t.PrE
Pre-blinking time
1.0”
0.5” - 1’00
Before any barrier movement, blinker will be activated for
t.PrE
time, to
warn about the incoming motion
no
Function deactivated
t.P.Ch
Different closing pre-flashing time
no
0.5” - 1 ’00
If this parameter has a value assigned to it, the control unit will activate
pre-flashing prior to closure for the length of time set in this menu
(adjustable time from 0.5” to 1’00)
no
The closing pre-flashing time corresponds to
t.PrE
P.AP
Motor power in opening phase
80
30 - 100
The displayed value is the percentage of max. motor power
P.Ch
Motor power in closing phase
80
30 - 100
The displayed value is the percentage of max. motor power
Pr.AP
Motor power during opening slow down phase
25
0 - 70
The displayed value is the percentage of max. motor power
Pr.Ch
Motor power during closing slow down phase
25
0 - 70
The displayed value is the percentage of max. motor power