V2 NIUBA-24V Manual Download

Page: 52 / 132

ENGLISH

- 50 -

11 - CONTROL PANEL

11.1 - DISPLAY

When power is on, the control unit checks that display correctly
operates by switching on all segments for 1.5 sec.

8.8.8.8

Firmware version, e.g.

Pr 1.0

, will be viewed in the following

1.5 sec.

Panel will be viewed upon completion of this test.

PLEASE NOTE: The display is off when the control unit is in
ENERGY SAVING mode.

The control panel represents the physical status of the terminal
board contacts and of the program mode keys: if the upper
vertical segment is on, the contact is closed; if the lower vertical
segment is on, the contact is open (the above picture shows an
instance where the inputs PHOTOCELL, SAFETY RIBBONS and
STOP have all been correctly connected).

The BLOCK input is connected to a micro-switch that is operated
by the inspection lock. In the case of the hatch opening, the
control unit is BLOCKED:

• Bar operation commands, from both the terminal block and

the remote controls, are not accepted

• The functions controlled by the

keys, for exploring

the programming menu and for operating the bar, are
permitted

• The display shows the status of the segments, alternating with

the message “

SbLo

”

Points being among display digits show the status of
programming push-buttons: as soon as a push-button is pressed,
its relevant point turns on.

The arrows on the left of the display show the state of the start
inputs.

The arrows light when the related input is closed.

• The arrow further at the top is illuminated when the barrier is

in opening phase. If it flashes, it indicates that the opening has
been caused from the participation of an emergency device
(obstruction sensor or obstacle detector).

• The center arrow indicates that the barrier is opened in

pause. If it flashes it means that the time counter is active and
counting for the automatic closing.

• The lower arrow is illuminated when the barrier is in phase

of closing. If it flashes it indicates that the closing has been
caused by an interruption of an emergency device (obstruction
sensor or obstacle detector).

11.2 - USE OF THE KEYS FOR
PROGRAMMING

The control unit functions and times are programmed by means
of a special configuration menu, which can be accessed and
explored by using the 3 keys,

and

, located on the side of

the control unit display.

PLEASE NOTE: Outside the configuration menu, pressing
the

key activates the START command, pressing the

key

activates the PEDESTRIAN START command.

There are the following three kinds of menu items:
•  Function menu
•  Time menu
•  Value menu

Function menu setup

Function menus allow selecting a function from among a group
of available options. When you enter into a function menu, the
current active option will be viewed; you can scroll all available
options through

and

keys. By pressing the

key, you

will activate the option viewed and you will return to the
configuration menu.

Time menu setup

Time menus allow setting a function duration. When you enter
into a time menu, the current setup value will be viewed; the
display mode depends on the current value:

• Each time you press

key, current time value increases and

each time you press the

key, current time value decreases.

• By holding down the

key, you can quickly increase the time

value, up to reach the max. value allowed for this item.

• Vice versa, by holding down the i key, you can quickly

decrease the time value down to reach

0.0”

• In some circumstances, setting the value to

means that