Utax CDC 1725, Instruction Handbook Manual

Page: 49 / 436

Preparation before Use
2-13
2
Network Setup (LAN Cable Connection)
The machine is equipped with network interface, which is compatible with network protocols such as TCP/IP
(IPv4), TCP/IP (IPv6), IPX/SPX, NetBEUI, IPSec, and AppleTalk. It enables network printing on the Windows,
Macintosh, UNIX, NetWare and other platforms.
This section explains the TCP/IP (IPv4) Setup and AppleTalk Setup procedures. For other network settings,
refer to the Network Setup on 8-73 .
• TCP/IP (IPv4) Setup...2-13
• AppleTalk Setup...2-15
NOTE:
If user login administration is enabled, you can only change the settings by logging in with
administrator privileges. If user login administration is disabled, the user authentication screen appears. Enter
a login user name and password, and press [Login]. Refer to
Adding a User on page 11-5 for the default login
user name and password.
TCP/IP (IPv4) Setup (by Entering IP Addresses)
Set up TCP/IP to connect to the Windows network. Set the IP addresses, subnet masks, and gateway
addresses. The default settings are "TCP/IP Protocol:
On , DHCP: On , Bonjour: Off , Auto-IP: On ".
NOTE:
Prior to the IP address entries, obtain permission from the network administrator.
Auto-IP is available with 55/50 ppm model.
Use the procedure below.
1
Press the System Menu key.
2
Press [System], [Next] of Network and then [Next]
of TCP/IP Setting .
3
Press [Change] of TCP/IP .
4
Press [On] and then press [OK].
5
Press [Change] of IPv4 .
6
Press [DHCP].
7
Press [Off] of DHCP and then press [OK].
8
Press [Bonjour].
9
Press [Off] of Bonjour and then press [OK].
10
Press [IP Address] and enter the address using the
numeric keys.
11
Press [Subnet Mask] and enter the address using
the numeric keys.
12
Press [Default Gateway] and enter the address
using the numeric keys.
System - IPv4
Set TCP/IP (IPv4).
On
Default
Gateway
0.0.0.0
0.0.0.0
0.0.0.0
On
IP Address
Subnet Mask
Off
Bonjour DHCP
Status 08/08/2009 10:10
Cancel OK
On
Auto-IP