USC U-Batch, Operator'S Manual

Page: 31 / 118

Page 31
U-BATCH™ TREATER
LOAD / UNLOAD SCREEN
1. LOAD OR UNLOAD TREATER:
Press the Lower Treater button and hold for two
seconds and the Inlet gate will open, the discharge gate will close, the air seal will
pressurize and the mix motor will start. This process will run until the operator presses
the stop button that appears after it is started. This works the same when unloading
the treater except the discharge gate will be in the open position.
2. LOWER OR RAISE TREATER:
Press the Raise Treater button and hold for two
seconds, the discharge gate will close and the raise indicator will show that the
hydraulic motor is operating. This process will run until the pre-determined time has
elapsed stopping the motor. This works the same when unloading the treater except
the motor runs in reverse.
3. LOWER OR RAISE TIME:
The treater will raise and lower to a fixed high and low
position. Press these buttons to set the amount of time for the treater to travel the
fixed distance. When the process has started, the button becomes an indicator
counting down the number of seconds left to completion.
1
2
3