USC U-Batch, Operator'S Manual

Page: 48 / 118

Page 48
U-BATCH™ TREATER
SETPOINTS 3 SCREENS
1. VFD ERROR FAULT:
Pressing this button pops up a numeric keypad allowing the
operator to enter the number of seconds from the time a VFD fault is detected until the
system alarm activates.
2. DISCHARGE OPEN /W INGREDIENTS:
Pressing this button pops up a numeric
keypad allowing the operator to enter the number of seconds until an alarm sounds
from the time either of the pump stand motors start or the air begins to feed powder
from the applicator when the discharge gate is in the open position.
3. AIR SEAL WARNING:
Pressing this button pops up a numeric keypad allowing the
operator to enter the number of seconds from the time the Air Seal should begin before
issuing a warning. It is unlikely this will activate because the Mixer and Air Seal
buttons are interlocked
4. OVER MIX WARNING:
Pressing this button pops up a numeric keypad allowing
the operator to enter the maximum number of seconds that a batch may run before
a popup warning informs the operator that it has been running longer than the amount
of time designated here.
2
4
3
1