USC U-Batch, Operator'S Manual

Page: 36 / 118

Page 36
U-BATCH™ TREATER
PUMP SETUP SCREENS
MODE: Direct Translation
–
Allows the
operator to set pump in oz / min. The flow
rate will be maintained using the output
from the flow meter.
MODE: Off - Allows the operator to
define the pump speed in two ways.
One is by checking the Target Rate box
and entering the ounces to apply per
minute. The other is to check the Pump
Percentage box and key in the percent
of full motor speed. If the treater is running
in Batch mode, define the batch application
time in seconds as well as the compressed
air supply line purge.
MODE: Batch Translation
–
Allows the
operator to set pump flow rate by total
ounces per batch. Enter the toatal amount
to be used in the Pump 1 box. Enter the
total run time for the batch and the system
will calculate the ounces per minute
required.