USC U-Batch, Operator'S Manual

Page: 14 / 118

Page 14
U-BATCH™ TREATER
Installation
Section
B
4. Inspect U-
Batch™ Treater thoroughly for screws, bolts, fittings, etc. which may
have come loose during shipping.
5. Positioning the treater with standard legs:
Use the forklift to raise the U-
Batch™ Treater high enough so the legs may be
installed. Attach the four horizontal legs (P\N 05-05-0123) to the base of the
machine. Then, attach the four vertical legs (P\N 05-05-0122) to the horizontal
legs (see page 112).
Lower the machine and place it in the final working position. Make sure there is ample
room for a forklift to remove full pro boxes and replace them with empty ones.
Place the inlet conveyor and ensure proper access to the pro box stand. Anchor the
treater to the floor to prevent the machine from moving during operation.
SET-UP
The following steps outline the initial set-up of your U-
Batch™ Treater :
1. Clear the area of bystanders, especially small children, before moving.
2. Be sure there is enough clearance from overhead obstructions and power lines
or other equipment to move the machine into its working position.
3. Using a forklift, place the U-
Batch™ Treater in the desired position on a level
surface.
USC highly recommends that the U-
Batch™ Treater be set up
inside a building or any covered structure to protect the machine
from weathering.
NOTICE
HIGH VOLTAGE ~ Always disconnect the power source
before working on or near the control panel or lead wires.
HIGH VOLTAGE ~ Use insulated tools when making
adjustments while the controls are under power.
Permanent installation may require additional electrical cords,
chemical tubing, and air lines, since each installation is unique.
NOTICE