USC U-Batch, Operator'S Manual

Page: 55 / 118

Page 55
U-BATCH™ TREATER
Maintenance
Section
G
Proper maintenance of the U-
Batch™ Treater is critical for peak performance, reliability
and accuracy of this system. The following is a guideline for the type of maintenance
and servicing that should be performed on this unit. Your environment and uses may
require additional maintenance and service beyond this list to assure a reliable and
safe unit. The operator of this unit has ultimate responsibility to identify areas of
concern and rectify them before they become a hazard or safety issue. There is no
substitute for a trained, alert operator.
Do not put this unit into operation with any questionably
maintained parts. Poor performance or a hazard may occur.
FLUIDS AND LUBRICANTS
Grease
Use an SAE multipurpose high temperature grease with extreme pressure (EP)
performance. Also acceptable is an SAE multipurpose lithium-based grease.
Hydraulic Oil
Use DTE 25 hydraulic oil for Electric Powered Hydraulic Pump.
Lubrication Oil
The lubricant is a factory filled high performance, H1 grade synthetic. The standard
ambient temperature range is
–
10 degrees to +130 degrees Fahrenheit.
Other lubricants, including Mobile SHC series must not be mixed with the factory
supplied lubricant.
Storing Lubricants
Your machine can operate at top efficiency only if clean lubricants are used. Use clean
containers to handle all lubricants. Store them in an area protected from dust, moisture
and other contaminants.
GREASING
Use a Maintenance Checklist to keep record of all scheduled maintenance.
1. Use a hand-held grease gun for all greasing.
2. Wipe grease fitting with a clean cloth before greasing to avoid injecting dirt and grit.
3. Replace and repair broken fittings immediately.
If fittings will not take grease, remove and clean thoroughly.
Also clean lubricant passageway. Replace fitting if necessary.
NOTICE