| 17
Maintenance and Service
Top Light Replacement
Occasionally the top light bulb will need to be replaced.
Replace the top light as follows:
1.
Disconnect electrical power to the unit.
2.
Remove outer glass
(see page 20).
3.
Remove inner glass
(see page 22).
4.
Use a 5/16 socket to remove the 4 fasteners
securing top light assembly; let assembly drop slowly.
5.
Grab connectors firmly at the base and disconnect
from bulb assembly; remove assembly from unit.
6.
Use a T20 screwdriver to remove light
cover. Replace light gasket if damaged.
7.
Replace light assembly (50-1516) or replace bulb with
120V, Halogen G9, 25W and assemble back into unit.
8.
Reconnect electrical power.
Remote Syncing
The remote should be synced to your fireplace by your
installer during installation.
Your remote may gradually lose its RF connection strength
over time. Resync the remote if this happens or if the
batteries have been changed. Resync remote as follows:
LOCATION OF SWITCH PANEL
IN BETWEEN FRONT GLASS
AND FIREPLACE CABINET
REMOTE
SYNC
BUTTON
POWER VENT
SWITCH
(INSTALLER USE
ONLY)
1.
Locate the switch tool supplied
with your fireplace (see photo).
2.
Locate the hidden switch panel
mounted on inner fireplace cabinet.
3.
Slip the tool in between the front
glass and cabinet and press the middle
switch. You will hear 3 beeps from the IFC.
4.
On hearing the 3 beeps, press the ON/OFF
key on your remote; you will hear 3 more beeps
to acknowledge successful remote syncing.
5.
Press the ON/OFF key again to turn off the
remote. The remote is now ready to use.
MAIN
BURNER
SWITCH
