06
HOW TO ACTIVATE THE SYSTEM
After the screw has been positioned correctly, the machine emits 4 beeps and deactivate tamper output.
It is always recommended to fix the fog generator to a wall even when it is placed on a flat surface. The
optional bracket, is always recommended to simplify the installation, allowing to use back holes for the
passage of cables. Remember to use the fixing screw placed in the cylinders compartment.
Always verify that the bracket or the support surface are suitable for the weight of the machine.
It is suggested not to install the machine behind walls in a limited closed area without a specific
ventilation, in order to prevent a possible overheating.
CAUTION:
to avoid injuries please securely fix the fogging machine to the wall according to the installation
instructions. In case of installation behind a wall, it is possible to request a nozzle extension, 7 cm.
After removing the machine from the package, unscrew the two screws that stop the right side
panel and remove it. Remove tamper screw and shell screws from inside.
At this point it is possible to remove frontal shell and see electronic circuit, from here on called PCB.
The screw in lower left part of cylinders’ compartment door is longer than the others and its
removal activates the tamper output.
t is recommended to install the fogging system Fast 01 2C PRO PLUS vertically. If it is needed to install Fast 01
2C PRO PLUS horizontally, it is necessary to order a special machine prepared for such installation and strictly
follow the installation instructions.
6