P a g e
| 21
ÜKY/Duopel Boilers User Manual
To manually burn and burn:
Big fuel parts like log wood that are wanted to be burned in the boiler are placed inside the boiler by opening
the top cover.
Open the control panel by pressing the
ON/OFF button of the device for
1 second. The boiler is put into manual feeding by pressing the
Wood
Mode button. In wood mode;
Gearmotor On / Off and
Manual
Fuel Feed,
Fuel Feed and
Fuel Standby will not work.
The boiler does not work because the
Gearmotor On / Off and
Fan On / Off button is not pressed in the side display.
It is useful to set the boiler water temperature at 60
o
C for the first time. To do
this, first press the
Temperature Setting button on the panel.
TEMPERATURE SET will appear on the screen. You can hold down the
buttons until the temperature level you want to adjust.
When it reaches the desired degree, you can save it by pressing the
ENTER
button.
Press the
Fan Setting button of the panel. The rectangle will appear
around the line in the upper left corner.
When you press the
button once, you increase the fan stage once again, as
in the second figure, the moment you press the
ENTER button, the fan
setting you have memorized and the image on the screen will be as in the third
figure.
Ignite the ignition aids you put in the boiler. Then close the boiler covers tightly
and press the
Fan On / Off button on the panel. The Fan lamp on the top
right of the control panel will illuminate and the boiler will continue to heat.
It will be sufficient to press the
ON / OFF button to turn off the boiler. Unless the power is
disconnected (power failure, removal of the boiler plug), the pump will continue to run until the temperature
drops.
