P a g e
| 20
ÜKY/Duopel Boilers User Manual
It is useful to set the boiler water temperature at 60
o
C for the first time. To do
this, first press the
Temperature Setting button on the panel.
TEMPERATURE SET will appear on the screen. You can hold down the
buttons until the temperature you want to adjust is reached.
When it reaches the desired degree, you can save it by pressing the
ENTER button.
Press the
Fan Setting button of the panel. The rectangle will appear
around the line in the upper left corner. When you press the
button once,
you increase the fan stage once again, as in the second figure, the moment you
press the
ENTER button, the fan setting you have memorized and the
image on the screen will be as in the third figure. The fan speed will remain at
Level 1 during the ignition.
Find the Fuel Feed and Fuel Standby settings in the "Fuel Standby - Feed
Settings" section of your manual, which should be based on the boiler power
and fuel type.
Press
Fuel Feed button to adjust the amount of fuel to be fed into the
boiler. After adjusting the required feeding setting from
buttons,
press the
ENTER button to store it. Press the
Fuel Standby
button to set the standby. After setting the standby setting that should be from
the
buttons, press the
ENTER button to store it.
If it is desired to increase the extra energy during combustion, the spiral is driven by pressing the
Manual Fuel Feed button. This button supplies fuel as long as it is pressed, and cuts the feed when the finger
is pulled.
It will be sufficient to press the
ON / OFF button to turn off the boiler. Unless the power is
disconnected (power failure, removal of the boiler plug), the pump will continue to run until the temperature
drops.
