Unitec SSA-003, Manual

Page: 52 / 55

52
motor shields. The front of the triangle must put into the groove
more than two-thirds.
4): How to change the long blade
’
s motor : Switch off the power,
take off the motor shields, motor fixed frame and travel switch..
Then loosen the triangle screws by six concern screwdriver, the
triangle and screw shall put out together. With a screwdriver loosen
the eccentric wheel direction
’
s screws ,take the eccentric wheel out
and loosen the three the panel
’
s fixed screws .At last, pull out the
wire.
Setting: set up the fixed screws, eccentric wheel, triangle, travel
switch and motor fixed frame, motor shield successfully. Then
insert the wire.
5): Stripper pad exchange: Use the "_" screwdriver to move the
rubber roller to another side then lift, put out the rubber roller, take
off the leather,exchange a new leather, the bearing side should be
align at the rubber roller's connector.
6): How to change the give paper round
：
Open the head cover,
move the pressure roller to both side,push the pressure roller barb
so that it can move when it break away from the groove. Pull out the
paper shaft and insert it. Pay a attention to the direction. ( when the
paper shaft stop naturally, pressure roller shall be planed down.)
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn