Unitec SSA-003, Manual, Page: 50 / 55

50
cutting compensation or sign position compensation. When the
card is forward gradually 0.5mm from the front-end mode,press the
“
Set parameter" to choice the first cutting compensation, then press
the "-" key to reduce 0.5mm. If the error comes form measure black
mark mode,press the "Set parameter
”
to choice the sign position
compensation, according to the above method of operation.
D: When the cards' corner is not be a right angle. We shall change
the Rotary blade's place.
Method: Switch off the power,take off the head cover,loosen the two
black screws, take apart the left cover,then loosen the screw which
on the Rotary blade
’
s fixed bracket. Then unscrew the screws
which on the bottom left to adjust the angle. If the card was left
inclined,move the screw like a counter-clockwise. If the card was
right inclined, move the screw like a clockwise.
2: Change the two parts
1): How to change the Rotary blade: Standing in the switch
direction. Switch off the power supply, take off the cover, loosen the
four black screws by hand. Hold on the knife.lift the knife and pull it
out.
Installation
：
Standing in the switch direction, switch off the power
and hold the knife,let the cogged side blade align at the right
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn