Unitec SSA-003, Manual, Page: 51 / 55

51
panel's long circle hole.and the another side of the blade closed to
the rotary blade bracket. To make sure that the tooth could match
the machine completely. Then tight the 4 screws.
2): The side cover's assemble and disassemble
Disassemble: take off the right cover
（
the side which has no
operation panel called right cover).
Switch off the power, take off the head cover, loosen the two screws
under the machine by "+"screwdriver. After that, loosen the other
two inside screws on the machine and pull the cover out gently. The
same method as the left cover. When set up ,we must put on the
left cover first then clock the inside screws.
3): Replaced the Long blade assembly: Switch off the power and
take off the the head cover, remove the left and right side cover.
Dismantle the long blade shields, motor fixed frame and travel
switch. Then tear down the left and right bracket and the under
fixed screws by six concern screwdriver.pull out the wire,hold the
motor and lift it slowly.
Setting up: Hold the motor and let the wire through the left panel.
Then put up the motor,put the other side of the blade on the left
bracket, put down the motor and clock the under screws. After that,
setting up the long blade, travel switch, motor fixed frame and the
PDF 文件使用 "pdfFactory Pro" 试用版本创建 www.fineprint.cn