Unisys e-action Source NDP, Installation And Operation Manual

Page: 29 / 111

Source NDP Operation and Document Processing
3–4 4326 6295–002
Using the Start/Stop Button to Clear the Track
If a document or documents stop in the track during processing, hold down
the Start/Stop button for several seconds. This action starts the track motor
and normally ejects documents into a pocket for reprocessing.
When a jam occurs, it may be necessary to take other actions to clear the
track. Refer to “Clearing the Track,” in Section 6.
Status Lights
Three lights on the front of the unit (Figure 3-4) indicate the status of the unit
and the application that runs on the host PC. Some applications add audible
messages to indicate status.
Figure 3–4. Status Lights
The sequence of lights you normally see when powering on the Source NDP
unit is described in “Powering the Unit On and Off,” earlier in this section.
During normal operation, the Ready light remains solid green while
documents are flowing. It blinks green if documents stop, which may
occur if the application is slow in processing information or if the network is
slow. It may also blink green if the Source NDP unit is capturing OCR as well
as MICR data because the application is stopping and quickly restarting
documents in the track loop area.
The following table describes the meaning of each status light and gives
corrective actions for problem conditions. Refer to Section 6 for additional
information about recovering from problem conditions.