65
[insert the following here: 3 LCD illus such as on page 113 of V 1.02 Op Spec. For each screen, place small circle number
near or almost on a display line or abbreviation such as DXG, DRD, L/O, Hollywood etc. Then make a list of meaning for
each next to or below the screen]
Care and Maintenance
General Use
Turn the scanner off before disconnecting the power.
If memory is lost, simply reprogram each channel.
Always press each button firmly until you hear the entry tone for that key entry.
Location
Do not use the scanner in high-moisture environments such as the kitchen or bathroom.
Avoid placing the unit in direct sunlight or near heating elements or vents.
If the scanner receives strong interference or electrical noise, move it or its antenna away from the source of the noise. If possible,
a higher elevation might provide better reception.
Also try changing the height or angle of the antenna.
Cleaning
Disconnect the power to the unit before cleaning.
Clean the outside of the scanner with a mild detergent.
To prevent scratches, do not use abrasive cleaners or solvents. Be careful not to rub the LCD window.
Do not use excessive amounts of water.
Repairs
Do not attempt any repair. The scanner contains no user serviceable parts. Contact the Uniden Customer Service Center or take it to
a qualified repair technician.
Birdies
All radios can receive “birdies” (undesired signals). If your scanner stops during Scan mode and no sound is heard, it might be
receiving a birdie. Birdies are internally generated signals inherent in the electronics of the scanner.
Press
[L/O]
to lock out the channel.
Troubleshooting
From time to time, Uniden might update the BCD996T’s firmware to change the scanner’s performance or incorporate new features.
These updates can be applied by you using the supplied PC cable and the software that we will provide. Please note that firmware
data must be input by means of the front panel serial cable connection, not the rear connector. We recommend you visit the Uniden
web site periodically to check for the latest updates.
However, if you believe your BCD996T is not performing properly, try these suggestions.
Problem Possible
Cause
Suggestion
The scanner doesn’t
work.
The scanner might not be
receiving any power.
Make sure the AC adapter is
connected to an AC outlet
and the scanner. The display
should light and cycle if you
repeatedly press
[VOL]
