57
Set Data Skip
◙
This setting controls how the scanner behaves when it stops on a channel that has a data signal.
On
— the scanner stops briefly on the channel, but then immediately resumes scanning automatically.
Off
— the scanner remains on the channel until the transmission stops. The default setting is
Off
Notes:
If you are trying to test the Close Call feature with a nearby transmitter (such as a CB) and you do not talk into the transmitter, the
scanner detects this unmodulated carrier as data and skips the frequency when Data Skip is on. Turn the feature off or talk into the
transmitter to modulate the carrier.
This setting is ignored for AM/WFM/FMB channels.
Setting the Delay Time
[MENU]
Srch/CloCall Opt
◙
Set Delay Time
◙
This setting determines how long the scanner waits after a transmission ends before resuming Quick Search or Close Call operation.
1-5 sec
The scanner waits the set amount of time after the transmission ends before resuming. The default setting is 2 sec.
Off
The scanner resumes immediately when the transmission ends.
Setting the Search Frequency Step
[MENU]
Srch/CloCall Opt
◙
Set Step
◙
This setting lets you select the frequency step used for setting the channels.
Auto
The step is based on the band (see the table at the front of the manual) This is also the default setting.
5.0 kHz, 6.25kHz, 7.5 kHz,
8.33kHz, 10.0 kHz, 12.5 kHz,
The scanner uses the selected step.
15.0 kHz, 20.0 kHz, 25.0 kHz,
50.0 kHz, 100.0 kHz
Setting Record
You can set the
RECORD OUTPUT
jack to provide an audio signal to a sound recording device (tape, PC, flash memory) for live
recording of transmissions.
[MENU]
Srch/CloCall Opt
◙
Set Record
◙
On
—
enables an output to an audio recorder at the
RECORD OUT
jack.
Off
—
disables an audio signal at the output jack.
Adjust P25 Level
You can select the best threshold for the APCO mode.
[MENU]
Srch/CloCall Opt
◙
Adjust P25 Level
◙