19
D2
W
Cell #1
Press (ESC) to return . . .
WL : 656.1nm Abs:
12: 35: 27
-1.0 Abs 4.0
0
C
o
n
c.
7
6
Fig 35 square fit
D2
W
Cell #1
Press (ESC) to return . . .
WL : 656.1nm Abs:
12: 35: 27
-1.0 Abs 4.0
0
C
on
c.
9
1
4
3
8
Fig 36 cubic fit
D2
W
Cell #1
Press (ESC) to return . . .
WL : 656.1nm Abs:
12: 35: 27
-1.0 Abs 4.0
0
C
o
n
c.
7
6
Fig 37 linear fit
3.3.5 Press
【
SAVE
】
to save calibration if required
3.3.6 Press
【
ESC/STOP
】
to exit
4.Quantitative Test
Before test,the standard curve must be obtained.There are three ways
for you to obtained it (a, b or c).
a) Standard curve built up and saved in the instrument.
In Fig 33 press
【
Load
】ａｎｄ ｔｈｅｎ ｐｒｅｓｓ【
∧
】
or
【
∨
】
to select the
file with type ***.fit. At last press
【
ENTER
】ＴＯ ｃｏｍｆｉｒｍ．
b) Known standard curve, which is not saved in the instrument.
See 3.2. For Fig 29 enter a known standard curve directly.
c) Use the standard samples for the test. First the standard curve must
be established using the method shown in 3.3.
Note: All sample results must be taken in screen Fig26.
