ULTRAFRYER Systems PAR-3-14HE CE, Operating Instructions Manual

Page: 33 / 43

d. Turn the RIGHT HAND Topside Shortening Return Lever 1⁄4 turn counter clock wise; then CAREFULLY remove the
Wash Down Hose MALE In-Line Plug from the TOPSIDE FEMALE SOCKET by depressing the Topside Socket Release
Knob.
e. Hang the Wash Down Hose in an up-right position so shortening can drain into a metal container; then proceed to para-
graph B 1 below.
B. POLISHING SHORTENING
1. Set a timer for the amount of time established for POLISHING shortening, then turn the VAT SHORTENING RETURN
LEVER 1/4 TURN COUNTER CLOCKWISE to allow shortening to circulate through the system to POLISH the
shortening.
2. At the end of the established time, TURN the VAT SHORTENING RETURN LEVER 1/4 TURN CLOCKWISE, turn the
DRAIN VALVE HANDLE to the closed UP position; replace the grill in the fryer; then TURN the Vat Shortening RE-
TURN LEVER 1/4 COUNTER CLOCKWISE to automatically return shortening in the filter tub to the fryer vat.
3. When all shortening in the filter tub has been returned to the fryer, TURN the VAT SHORTENING RETURN LEVER,
1/4 TURN CLOCKWISE check and if necessary add fresh shortening so shortening is level with the middle line of the
letter “E” in the word LEVEL of the shortening level mark on the rear wall of the fryer.
4. Remove the Filter Tub Assembly by pressing the DOCKING RELEASE HANDLE and pulling the STANDPIPE DOCK-
ING HANDLE ASSY away from the FEMALE Bulkhead Socket adjacent to the Drain Valve; then THOROUGHLY
clean, assemble and replace the Filter Tub Assembly in the fryer cabinet.
(Basket Hanger Bracket Not Shown For Clarity)
Wash Down Hose
Guide
Topside Socket Release
Knob
Topside Female Socket
and Proximity Sensor
Switch
CAUTION: DO NOT POLISH THE SHORTENING MORE THAN THE ESTABLISHED TIME AS IT WILL
PUMP EXCESS AIR INTO THE SHORTENING CAUSING SHORTENING BREAKDOWN.
Page 26
30A134