INSTALL GUIDE
PAGE 6
IMPORTANT!
The system must be Tach Learned before remote starting.
Auto Tach Learn:
Start the vehicle with the key. To confirm that a proper tach signal is
detected the system will flash the park lights and the horn (optional)
will honk three times.
Optional Tach Learn (
vehicles without 12volt start output
):
Press and Hold
the brake pedal. Start the vehicle with the key then
press and release the program button 2-3 times within 2 seconds.
To confirm that a proper tach signal is detected the system will flash
the park lights and the horn (optional) will honk three times.
* If tach does not learn check for proper connection on the BLUE ignition
wire at the 6-pin connector. This wire should be connected to the vehicle
main ignition wire and must not turn off during the start position. If the
ignition connection is correct, reset the system (System Reset page 7).
New - If the original Tach source is changed a system reset must be
preformed before a new tach signal can be learned to the system.
For best results connect the tach wire to a fuel injector wire.
(See page 7 for System Reset).
NOTES: 1) If the vehicle does not start when the remote starter
is activated, the park lights will flash a diagnostic
code. (See Diagnostic Chart page 16).
2) If the vehicle still does not start, check all connections
and check for a factory installed Anti-Theft system.
Auto/Optional Tach Learn
