PAGE 7
INSTALL GUIDE
A system reset will clear any changes made to the Program Menu’s
as well as the Tach setting. When the system reset is complete the
system must be Auto Tach learned before the remote starter will
operate.
1)
Within 3 seconds turn the ignition key from “Off” to “On” 3 times,
ON-OFF-ON-OFF-ON.
(Leave the key in the
ON
position)
2)
Press and release the
Program Button
located on the antenna.
The park lights will turn on and the horn (optional) will honk one time.
3)
Then press and hold the
Program Button
until the park lights flash
and the horn (optional) will honk 3 times to confirm system reset.
NOTE:
System Reset
does not
delete the transmitter codes from
memory and
does not
default MENU 2, SETTING 1.
System Reset
Remote Transmitter Learn
STEP 1
- Within 3 seconds turn the ignition key to the “
ON
”
position three times leaving “
ON
” the third time.
NOTE:
STEP 3
- While holding the Program Button, press and release the
button on each of the remote transmitters to be programmed.
If the parking lights do not turn “ON”, release the Program Button and
turn the ignition to the “OFF” position, wait 5sec and repeat steps 1 & 2.
STEP 2
-
Press and hold the Program Button.
The park
lights will turn “
ON
” and the horn (optional) will
honk once.
Continue to hold the Program
Button
, the park lights will turn “
OFF
” and the
horn (optional) will honk 5 times quickly.
IMPORTANT! All remote transmitters not programmed at this time
will be erased from memory for security.
