Installation Guide
OPERATIONS
Manual Transmission Remote Starters must have both the door trigger and park brake wires connected. Most
installs will require a clutch bypass. This is a temporary bypass. The clutch should only be bypassed during the
activation of the remote starter. Never disconnect or alter the switch to be always bypassed. Always use a
“M
”
Series Remote Starter on a manual transmission vehicle.
Never
install a automatic Remote Starter model into a manual transmission vehicle. It is not recommended to
install a remote starter on a convertible type vehicle. If doing so It is highly recommended that a radar sensor is
installed to cover the proximity of the gear shift lever. If the radar sensor is tripped the remote starter will exit
Reservation Mode.
To enter Reservation Mode, the following steps must be followed.
Step 1
- While the vehicle is running, place the transmission in neutral and apply the parking brake.
Step 2
- Press and release the brake pedal. The park lights will activate.
Step 3
- Turn the ignition key off and the vehicle will stay running.
Step 4
- Exit the vehicle and close the door. The vehicle will then shut off*.
Step 5
- The vehicle can now be safely remote started.
Reservation Mode will automatically be exited if the doors of the vehicle are opened.
The set-up mode will then have to be repeated . Reservation Mode Must be set-up each time the vehicle is
parked.
Note: If the vehicle is not in Reservation Mode and the Start button is pressed, the system will flash the
park lights four times slowly.
* If the vehicle has a dome light delay, the vehicle may stay running until the dome light turns off. This is normally
no longer than 30 seconds.
Press Once to Lock Doors and arm alarm (if equipped)
Press 2nd Time & Hold for Constant Lock Output
Press Once to Lock Doors and arm alarm (if equipped)
Press 2nd Time & Hold for Constant Lock Output
See Owner’s Guide for More Detail on Operations
Press Once for Unlock doors and Disarm Alarm (if equipped)
Press & Hold for Trunk / Aux Output
Press Once for Unlock doors and Disarm Alarm (if equipped)
Press & Hold for Trunk / Aux Output
Press Once for Start - (
2 Times if programmed for safety start
)
Press & Hold for 3 seconds while running to turn off
Press Once for Start - (
2 Times if programmed for safety start
)
Press & Hold for 3 seconds while running to turn off
Press once and hold for Car Finder
Press & Release then press START and hold for Timer Mode
Press & Release then press START and hold for Timer Mode
2nd Car Operation
Reservation Mode - Manual Trans.
Cold Start Mode
10
First Car
2nd Car
=
=
=
=
&
&
&
&
then
1.Press & release the
#
button, then press and hold the button for six seconds, until the parking lights
turn “on”.
2. While the parking lights are “on” the start cycle can be selected.
1 hour cycle or 0C
Press LOCK button
1 flash
2 hour cycle or -5C
Press UNLOCK button
2 flashes
3 hour cycle or -15C
Press button
3 flashes
4 hour cycle or -25C
Press button
4 flashes
3. System will start vehicle at selected cycle for up to 24 hours.
TO CANCEL COLD START MODE
1. Press & release the
#
button, then press and hold the button for four seconds.
2. The System will respond with two flashes and two horn honks (optional).
Note: Starting the vehicle with the key or remote starting the vehicle will cancel Cold Start Mode.