Installation Guide
Recommended Pre-Installation Procedures
- Control module
- Remote transmitter(s)
- Antenna with built in Program Button and LED’s
- 6 pin main harness with dual 30amp power inputs.
- 14 pin harness
- 4 pin keyless entry harness
- Hood pin safety switch
- Installation guide
- Owners manual
BEFORE STARTING INSTALLATION
:
- Discuss the optional features with the customer.
- Do a walk around the vehicle and check for any damage.
- If installing a LED discuss the placement with customer before installing.
Note:
This remote starter is designed for fuel injected and diesel engines
.
- Take a few minutes to review the installation and owners manuals.
- Check if the vehicle has a factory security or anti-theft system.
*If equipped, inform the customer of addition parts and labour.
Recommended Installation Procedures
INSTALLATION TIPS
Components
Under Hood Connections -
Route the hood pin and tach wires through the firewall into the engine
compartment. Always try to pull the wires through a factory rubber grommet. If drilling through the
firewall,
BE CAREFUL
. Check for obstructions on both sides of the firewall. After drilling use a snap in
grommet to protect the wires from sharp edges.
Proper Connections -
Remote Starters can handle loads of up to 30 amps for extended periods of
time. It is CRITICAL to insure that ALL high current connections are properly soldered and insulated
with quality electrical tape. Failing to insure proper connections will result in warranty being VOID and
can result in a FIRE. The manufacturer is not responsible for any such damages. It only takes a few
more minutes to do the job RIGHT.
Mounting The Control Module -
Never
mount the module in the engine compartment. Select a
location under the dash to install the main module. Be certain that the module is securely attached and
does not obstruct any serviceable areas. Do not force or jam the module into tight places instead of
mounting. The module must be free from all moving parts such as brake and clutch as gas pedals
linkages. Do not place the module directly in front of a heater vent.
Installing the External Long Range Antenna -
To insure the best possible reception, place the
antenna in the center of the windshield, behind the rear view mirror. Before attaching to the glass ensure
that the surface is clean and dry. For best results with range, place the antenna below the tint screen.
Run the cable under the head liner and behind the A-pillar panel. Be careful not to pinch the antenna
cable. Plug the antenna into the
BLUE
connector on the Control Module.
NOTE
: This step is not used on Alarm Only Units with no External Antenna.
Testing The System -
When the installation is complete, it will be necessary to test that the system
is working correctly. The system’s default programming will work on the majority of vehicles, but might
need to be adjusted for some applications. If the installation requires special timing or additional
features, proceed to Program Mode.
4
ATTENTION: Hood Pin MUST always be connected!!
NOTE: Always inform user to place system in Service Mode before any service work is
performed on the vehicle.
