Installation Guide
QUICK START INSTALL
Yellow
Starter Output
Connect To The Vehicles Starter Wire.
Green
Heater Output
Connect To The Vehicles Accessory Wire.
Red
12 power Input
Connect to Constant 12 Volt Power Source
-
High Current.
Red
12 power Input
Connect to Constant 12 Volt Power Source
-
High Current.
Blue
Ignition 1 Output
Connect To the Vehicles Primary Ignition.
White
Selectable
Jumper Selectable.
See page 5
6 Pin Power Connector
14 Pin Power Connector
Manual Transmissions Only
Step 2- Plug-In The Module
Step 3- Auto Tach Learn
Your Basic Install Is Complete!
Step 1 - Connect All Of the Following Wires
Black
System Ground
Connect To Chassis Ground.
Pink
Brake Switch
Connect To (+) When Brakes Applied.
White
Park Lights
Connect To (+) Park Light System.
Green/White Hood Pin
Connect To Hood Pin Switch.
Blue/White
Tach
Connect To A/C Tach Source.
Blue or Green
Door Trigger Input
Connect to Door Trigger
Black/White
Park Brake
Connect (-) Parking Brake
NOTE: Manual Transmission units MUST be set into RESERVATION mode to remote start.
See page 10 for details.
Your Basic Installation is Now Complete!!
1) Make all the required wire connections and plug-in the Unit.
**The park lights should flash twice upon power up.
2) Turn the Ignition Key ON. (Park Lights will turn on).
3) Start the vehicle, LED’s on antenna will come when proper tach signal is detected**, then after two to
ten seconds the park lights will turn off then flash twice to confirm tach learning.
* The system will flash the park lights seven times if not tach learned and the start button is
pressed. The system must be tach learned before remote starting.
** If the LED’s do not come on during tach learn, a proper tach signal was not detected
Note:
If the park lights do not flash in auto tach learn mode it may be necessary to connect to a different
tach source. For best results connect the tach wire to the coil pack or to a fuel injector wire.
See Page 8
for tach adjustment.
NOTES:
1) If the unit does not start, check the starter is not in Tach Lock Out or in Program Mode.
2) If the vehicle still does not start, check all connections and check for factory security.
When all the connections are done, the control module can be plugged in. Before connecting the control
module, make sure the ignition is in the
OFF
position. Plug in the 6 pin harness then the 14 pin followed
by any other connectors that were used.
6
ACTIVE RF ANTENNA
Status Leds
Program Button