UFO Basic L, Installation, Operation And Maintenance Manual

Page: 31 / 55

Installation, Operation and Maintenance Manual
UFO
31 uk.ufosecurity.com
Sensor battery change
PIR SENSOR:
1. Open the plastic casing by inserting a thin object such as a screwdriver into
the hole at the bottom of the sensor;
2. Disconnect the connection between the battery and the connector;
3. Connect the new battery to the connector;
4. Close the plastic shell.
REMOTE CONTROL:
1. Insert a screwdriver into the slot in the plastic casing of the remote control,
bottom left where the hole for the key ring is, and turn it until the casing
opens;
2. Using the screwdriver, remove the upper part of the body;
3. Remove the green card by turning the remote control upside down. The
CR2032 battery is located at the back;
4. Remove the battery from the tab, then insert the new one (taking care to
insert it with the positive side facing you);
5. Reinsert the card into the slot of the plastic casing (snap it in well), with the
4 buttons facing upwards (the ‘De Rem’ inscription on the card must read
upside down);
6. Close the casing well, placing the rubber covering correctly over the
buttons.
MAGNETIC SENSOR:
1. Unscrew the plastic shell.
2. Remove the ER14250 battery from the metal slot (the battery is wedged in
well, so pull it out with a little force).
3. Insert the new battery into the slot, making sure to put it in the correct
direction.
4. Screw the plastic shell back on.