109
Release the rear and front springs by putting wooden spacers between
the frame and the axles.
keep the preserved vehicle in a clean and ventilated room with the
relative humidity of 40-70 % and at temperature of +5°С at least.
Do not keep the vehicle and poisonous substances (acids, alkali etc)
in the same room.
PRESERVED VEhIClE MAInTEnAnCE
Carry out vehicle maintenance every two months. Do the following:
1. Thoroughly inspect the vehicle from the outside.
2. Screw off the spark plugs, disconnect the power wires from the
ignition coil and turn the engine crankshaft for approximately 15 torques
after shifting into the first gear of the gearbox and into the reduction gear
of the transfer case. Once a year fill the engine cylinders with 30-50 g of
engine oil before turning the crankshaft.
3. Clean any damaged areas of corrosion, grease and paint them.
4. Turn the steering wheel to both sides 2-3 times.
5. Check the parking brake and the pedal brake, the clutch, the throttle
gate drive and lighting switches.
6. Check fluid level in the tanks of the brake master cylinder. Add
the fluid, as required.
7. Check the electrical equipment instruments.
8. Check tools and appliances, wipe and grease them again, as required.
9. Check tires and other rubber parts.
10. Eliminate detected malfunctions.
DEPRESERVATIOn
1. Remove preservation grease from parts by washing them with
kerosene or unleaded gasoline. Thoroughly remove the grease from
items, which can contact rubber parts or painted surfaces. Thoroughly
wash the spark plugs in unleaded gasoline.
2. Carry out the daily vehicle maintenance.
3. Check oil level in the engine housing. Drain excessive oil.
4. Before starting the engine fill each cylinder with 30-50 g of the
motor oil and turn the crankshaft for 10-15 torques.
