47
gets clogged, remove it after extracting the clamp and detaching the pipe,
and blow it with compressed air.
To avoid failure of the washer pumps, check the water level in the
reservoir; 20 mm from the bottom is the lowest level permitted.
Do not keep washer reservoirs turned On for more than 10 sec.
Chapter 4. VEHIClE PrEPArATION AfTEr BUYING
Dealers must sell the vehicle only after pre-sale preparations, specified
in the service book.
If a vehicle is ferried to the selling point from the plant, works described
in "Daily Maintenance" section shall be completed.
Chapter 5. NEW VEHIClE rUNNING-IN
The vehicle long-term and fail-safe service life depends greatly on
the run-in of its parts during the initial service period.
The running-in distance is 2500 km.
During the running-in period, observe the following rules:
1. Avoid high driving speeds and maximum crankshaft rpm (engine
crankshaft rpm shall not exceed 3/4 of the rated value), change gears in
due time, depending on road and traffic conditions, comparing the engine
rpm with the driving speed.
2. Vehicle loading shall not exceed 50 % of the maximum value
during the running-in period.
3. Do not drive along tough roads (with deep mud, sand, steeps, etc.).
4. Do not haul a trailer.
5. Do not change oils filled in the engine and units at the manufacturing
plant.
6. Check and adjust the drive belts tension in the auxiliary units, if
necessary, as they reach the maximum stretch during the running-in period.
7. Check temperature of wheel hubs and in case of raised temperature,
loosen the tightness of bearings.
8. Check condition of all attachments and piping connections; eliminate
leakages of oils, fuel, coolant and hydraulic fluid, if any.
9. The scope of the vehicle maintenance is specified in the service book.
