98
engine gas distribution mechanism
Camshaft drive is a two-stage chain. Chain tension is provided
for by hydraulic tensioners.
WARNING!
Do not take the hydraulic tensioner out of the
chain cover to prevent disengagement of the piston with the casing
caused by the wrap spring.
The valves are driven from the camshafts directly via the
hydraulic pushers.Using the hydraulic pushers eliminates the
need for clearances adjustment.
engine lubrication system
The engine should be stopped immediately when a lubrication
system malfunction is registered.
WARNING!
The manufacturing facility set-in reduced size
engine oil filter is to be replaced at the first maintenance service
(after 2500 km, total kilometres logged) on one of the filters:
2101C-1012005-HK-2, 2105C-1012005-HK-2 manufactured by
'KOLAN' company or 409.1012005, 406.1012005-02 manufactured
by LLC 'BIG-Filter' company.
Regularly check up oil in the crankcase and fill it up as required.
Make the check before starting the engine. When checking the
oil level after the engine stops, it is necessary to wait for at least
15 minutes to allow the oil to drain into the crankcase. The
motor has been placed on a horizontal site. The oil level shall
be between MIN and MAX oil level gauge marks 10 (Fig. 9.2).
In case of frequent cross-country road trips, keep the oil level
near the «MAX» mark, not exceeding it. The volume of oil to
be added to the engine between MIN and MAX is 1 liter.
Engine oils of different grades and different manufacturers may
not be
mixed! If the engine oil of another grade or manufacturer
is to be poured, you must flush the lubrication system with
washing oil. The washing oil shall be selected in accordance with
the recommendations of the manufacturer of the newly poured
oil.
Fig. 9.1. Sequence of the cylinder
head bolt tightening
Summary of Contents for PATRIOT
Page 183: ...Memo...
