158
Starter drive should move freely with no jamming at the shaft
splines, and it should return to the source position by the return
spring. The anchor should not revolve when the drive gear goes
in the working rotation direction. In case of reverse rotation
the gear should revolve with the shaft. Check the ease of rotor
rotation in bearings with the brushes lifted by turning the shaft
by hands .
Warnings:
1. The sleeve of starter travel can be broken if the starter is
on after the engine begins working.
2. Do not wash the starter caps and the drive with gasoline
or kerosene to prevent the grease from being removed from the
bronze graphite cellular plain bearings.
WARNING!
It is prohibited to move the motor vehicle with
the starter. The starter should work no more than 10 seconds
uninterruptedly. Turn on the starter again after min. 1 minute,
no more than 3 times. If the engine cannot be started, detect and
eliminate the malfunction.
lighting system, light and audio alarm
lamp maintenance
consists in its adjustment and replacement
of bad ones.
Adjust the headlamps as follows:
1. Park the motor vehicle, which should have a full fuel tank,
its curb weight, normal tires pressure and loaded driver's seat
(750 N/75 kgf), on an even level ground 5 meters far from the
screen with special markings (Fig. 9.40).
2. Move control 3 (see Fig. 3.4) of headlamp adjuster to 0
position.
3. Switch on low beam and, closing each headlamp in turn,
rotate adjusting screw 1 (Fig. 9.41) and adjusting gear 2, so that
cutoff line from E and E' points on the left coincides with line
1 and on the right coincides with lines 2 and 2' for the left and
right headlamps respectively.
Headlamp replacement.
To change T/signal lamps remove the
connector from socket 6 (Fig. 9.41), turn the socket clockwise
(for the right headlamp) or counter-clockwise (for the left
headlamp) and remove the socket with the bulb.
Summary of Contents for PATRIOT
Page 183: ...Memo...
