120
Gas exhaust system
WARNING!
Working temperature of neutralizer and gas
exhaust system parts is 400-600°C. Do not use the motor vehicle
without neutralizer protecting screens. While driving and when
parked, ensure the exhaust system does not contact any flammable
materials (e.g. dry grass).
Exhaust gases leak in couplings is forbidden and should be
rectified at first notice. Tighten heat attached nuts (see Annex
2) after rinsing threaded connections with specific fluids.
The motor vehicle operation modes, in which ingress of unburnt
fuel into the exhaust system is possible, are not permitted.
Pay special attention to the operation of the feed system, the
valve control system, the inlet system.
Microprocessor controlled fuel injection system
WARNING!
Use only the diesel fuel complying with the
requirements of GOST R 52368. Various additives for fuel
(including gasoline, kerosene etc.) may not be used. If the above
requirements are not met, UAZ, PC shall bear no warranty
responsibility in case of the fuel equipment failure.
Precautions.
1. Prior to dismantling and installation of any components or
wires of the control system, disconnect the rechargeable battery
ground wire.
2. The engine may not be started if the rechargeable battery
and the ground wire between the engine and the body are not
connected reliably.
3. The rechargeable battery may not be disconnected from the
motor vehicle in-vehicle network while the engine is running.
4. If being charged from an external source, the rechargeable
battery must be disconnected from the in-vehicle network.
5. Do not expose control unit to temperatures above 80°C,
e.g. in a desiccator.
6. Prior to arc welding operations, disconnect the battery
wire and the control unit connector.
7. To prevent rusting of pins during vapour cleaning, do not
direct the nozzle to the system components.
WARNING!
Do not loosen or tighten fuel line connections while
engine is running or immediately after its stop.
Summary of Contents for PATRIOT
Page 183: ...Memo...
