90
ZMZ-51432 ENGINE STARTING
Fuel and oil should correspond to the season.
If necessary, release the air from the feed system, as suggested
in the "Engine" section.
Warning! Do not press the throttle pedal during the starting
of the engine!
Do not drive the motor vehicle right after the starting of a cold
engine.
After starting the engine, it should operate at minimum
idle speed for 1-2 minutes in order to put the turbocharger and
engine systems into working order. After this procedure, the
engine is ready for service.
Do not overload the engine when starting it cold. The optimal
service conditions of the engine are when the temperature of
the coolant is +60–95°C.
Starting a cold engine
1. Turn on the ignition.
2. If one of the temperature sensors (coolant, air or fuel
sensors) detects a temperature below +10°C, then the heating
plugs indicator starts to glow when turning on the ignition
.
The duration of pre-start warming up process with heating plugs
depends on the temperature conditions and state of the battery
charge.
4. Press the clutch pedal as far as it can go.
5. Switch on the starter.
6. Release the key after starting the engine (turn off the
starter).
After starting the engine, heating plugs signal device stops to
glow, and the plugs continue to warm up the engine for some
time.
Try to start the engine not earlier than 15 — 20 seconds after
the first attempt.
If the engine does not start after the third attempt, stop the
ignition, detect and remove the malfunction.
Starting a hot engine
If all the temperature sensors detect a temperature above
+10°C, then the heating plugs signal device starts to glow for
about 2 seconds and switches off when turning on the ignition.
The engine is ready for starting
.
Summary of Contents for PATRIOT
Page 183: ...Memo...
