u-blox JODY-W2, System Integration Manual

Page: 65 / 84

JODY-W2 - System integration manual
UBX-18068879 - R14 Regulatory compliance Page 65 of 84
C1 - Public
Cet émetteur radio, IC: 8595A-JODYW263 été approuvé par ISED pour fonctionner avec les types
d’antenne énumérés dans la section Approved antennas avec le gain maximum autorisé et
l’impédance nécessaire pour chaque type d’antenne indiqué. Les types d’antenne ne figurant pas
dans cette liste et ayant un gain supérieur au gain maximum indiqué pour ce type-là sont strictement
interdits d’utilisation avec cet appareil.
☞
Le dispositif de fonctionnement dans la bande 5150-5250 MHz est réservé à une utilisation en
intérieur pour réduire le risque d'interférences nuisibles à la co-canal systèmes mobiles par
satellite
☞
Opération dans la bande 5600-5650 MHz n'est pas autorisée au Canada. Haute puissance radars
sont désignés comme utilisateurs principaux (c.-àutilisateurs prioritaires) des bandes 5250-5350
MHz et 5650-5850 MHz et que ces radars pourraient causer des interférences et / ou des
dommages à dispositifs LAN-EL.
The internal / external antenna(s) used for this module must provide a separation distance of at least
20 cm from all persons and must not be co-located or operating in conjunction with any other antenna
or transmitter.
For ISED end poduct labeling requirements, see
End product labeling requirements .
☞
The approval type for all JODY-W2 variants is a single modular approval. Due to ISED Modular
Approval Requirements (Source: RSP-100 Issue 10), any application which includes the module
must be approved by the module manufacturer (u-blox). The application manufacturer must
provide design data for the review procedure.
Referring to the u-blox FCC/ISED certification ID
If the conditions in General requirements , FCC/ISED End-product regulatory compliance and all
Antenna requirements are met, the u-blox modular FCC/ISED regulatory authorization is valid and the
end-product may refer to the u-blox FCC ID and ISED certification number. U-blox may be able to
support updates to the u-blox regulatory authorization; for example, adding new antennas to the u-
blox authorization. See also
Antenna requirements .
⚠
To use the u-blox FCC / ISED grant and refer to the u-blox FCC ID / ISED certification ID, the
integrator must confirm to u-blox that all requirements associated with the
Configuration control
and software security of end-products are fulfilled.
Obtaining own FCC/ISED certification ID
Integrators who do not want to refer to the u-blox FCC/ISED certification ID, or who do not fulfil all
requirements to do so may instead obtain their own certification. With their own certification, the
integrator has full control of the grant to make changes.
Integrators who want to base their own certification on the u-blox certification can do so via a process
called “Change in ID” (FCC) / “Multiple listing” (ISED). With this, the integrator becomes the grantee
of a copy of the u-blox FCC/ISED certification. U-blox will support with an approval letter that shall be
filed as a Cover Letter exhibit with the application.
☞
For modules where the FCC ID / ISED certification ID is printed on the label, the integrator must
replace the module’s label with a new label containing the new FCC/ ISED ID. For a description of
the labeling requirements, refer to the JODY-W2 series data sheet [2].
☞
It is the responsibility of the integrator to comply with any upcoming regulatory requirements.