409-1993
AMP-TAPETRONIC Machines 69875 and 69875-1
Rev J
5 of 46
Tyco Electronics Corporation
508.0 mm [20.00 In.]
406.4 mm [16.00 In.]
609.6 mm
[24.00 In.]
1219.2 mm [48.00 In.] to top of 609.6 mm [24.00 In.] Reel
Power Requirements:3
Machine No. 69875 Ċ 115 Vac, Single phase with ground, 60 Hz
Power Requirements:3
Machine No. 69875-1 Ċ 230 Vac, Single phase with ground, 50 Hz
Production Rate:
Up to 2,500 - 3,000 terminations per hour, depending on operator experience
and general working conditions.
Wire Range:
No. 26 through No. 8 AWG, solid or stranded.
609.6-mm [24-in.]Dia. Reel Capacity:
1,500 to 5,000 terminals or splices, depending on wire size.
431.8-mm [17-in.]Dia. Reel Capacity:
1,500 to 5,000 terminals or splices, depending on wire size.
Magazine Capacity:
500 to 1,000 terminals or splices, depending on the wire size.
Weight:
Approximately 113.40 kg [250 lb.]
Figure 3
B. Wire Funnels
The wire funnel permits easier and faster wire entry into product wire barrels prior to the crimping
operation, and it acts as an extractor by sweeping the crimped product out of the die closure after
crimping. Wire Funnel No. 68299–1, for wire range 22 through 14 AWG, is installed on the machine at the
factory. Wire Funnel No. 68306–1, for wire range 12 and 10 AWG, must be ordered separately. Refer to
Section 8 for replacement procedure.
C. Electric Counter
An electric counter may be connected to the machine electrical system as shown in the wiring diagram in
Section 2. The counter must be supplied by the customer. The customer must ensure that the counter
voltage is of the correct rating.
2. DESCRIPTION
Machines 69875 and 69875-1 are identical except for the electrical systems required to power the machines. Machine
69875 operateson 115 Vac, 60 Hz; Machine 69875-1 operateson 230 Vac, 50 Hz power.
NOTE
i