409-1993
AMP-TAPETRONIC Machines 69875 and 69875-1
Rev J
3 of 46
Tyco Electronics Corporation
Figure 1
1. INTRODUCTION
AMP–TAPETRONIC Machines No. 69875 and 69875–1 (see Figure 1) were designed to crimp a variety of
tape–mounted products onto solid and stranded wires from No. 26 through No. 8 AWG by using replaceable
die sets.
The AMP–TAPETRONIC machines consist of a basic AMP–O–LECTRIC* Model “K” Terminating Machine and
the application tooling required to crimp PIDG* and PLASTI–GRIP* Terminals and Splices, AMPLI–BOND*
Terminals, DIAMOND GRIP* Terminals, STRATO–THERM* Terminals and Closed End Splices. See Figure 2.
This manual pertains to the applicator portion of the AMP–TAPETRONIC machine. For information about the
Model “K” AMP–O–LECTRIC machine, refer to Customer Manual 409–5128. For information beyond the scope
of these manuals, contact the Tooling Assistance Center at 1–800–722–1111.
Read this manual thoroughly before operating the machine. The performance of this machine will depend
largely upon the intelligent use of of the information contained in this manual.
When reading this manual, pay particular attention to DANGER, CAUTION, and NOTE statements.
Denotes an imminent hazard which may result in moderate or severe injury.
Denotes a condition which may result in product or equipment damage.
DANGER
CAUTION
!