409-1993
AMP-TAPETRONIC Machines 69875 and 69875-1
Rev J
37 of 46
Tyco Electronics Corporation
Figure 31
A
B
Tape Retainer
Slot of
Subassembly
Angles of
Teeth to Left
Install Feed Wheel and
Washerand Slide Up
Into Slot
Ends of Pin
Flush With
Sides of Yoke
Feed Yoke
Align Flat with
Setscrew
Tape Feed Belt Replacement
30. Adjust terminal guide to feed product straight into the crimping dies.
31. Replace the front and side guards before operating the machine.
9. PARTS LISTS AND DRAWINGS
This section contains parts lists and drawings which fully cover machine 69875 when used with Customer
Manual 409–5128. Figure 32 lists all parts for the applicator, and Figure 33 lists all parts added to the basic
AMP–O–LECTRIC Model “K” Terminating Machine. No die sets are listed in this section.
Refer also to the drawings shipped with the applicator and the machine.
10. REVISION SUMMARY
Since the previous release of this manual, the current TE logo was added.
Prior to this release, the following changes were made:
S
Reel Support Assembly in Figure 33 was revised
S
Wiring Diagram and Schematic were redrawn
S
Updated format to current corporate requirements
